Metacomp FAQ/Solution Re-interpolator
From CFD-Wiki
| Line 11: | Line 11: | ||
== Running from the GUI == | == Running from the GUI == | ||
| - | === Preparation Steps == | + | === Preparation Steps === |
In order to make things clear we will establish a naming convention. We will call the existing solution, the one we are interpolating FROM, the OLD solution. We therefore call the solution we are interpolating TO, the NEW solution. | In order to make things clear we will establish a naming convention. We will call the existing solution, the one we are interpolating FROM, the OLD solution. We therefore call the solution we are interpolating TO, the NEW solution. | ||
| Line 17: | Line 17: | ||
1. First rename the following files in the NEW solution folder: | 1. First rename the following files in the NEW solution folder: | ||
| - | cellsin.bin -------> new_cellsin.bin | + | ''cellsin.bin'' -------> ''new_cellsin.bin'' |
| - | nodesin.bin -------> new_nodesin.bin | + | ''nodesin.bin'' -------> ''new_nodesin.bin'' |
| - | 2. | + | 2. Copy theses two files from the NEW solution folder to the OLD solution folder |
=== Running the Tool == | === Running the Tool == | ||
| Line 29: | Line 29: | ||
[[Image:reintsom.png]] | [[Image:reintsom.png]] | ||
| - | |||
| - | == Running from the Command Line == | + | 3. Leave the default values and select the "Run Tool" button to start the run. |
| + | |||
| + | === Post Run Steps === | ||
| + | |||
| + | 4. Copy the ''new_cdepsout.bin'' file from the OLD solution folder to the NEW solution folder. | ||
| + | |||
| + | 5. Remove the ''new_'' appendage from each of the following files: | ||
| + | |||
| + | ''new_cellsin.bin'' | ||
| + | ''new_nodesin.bin'' | ||
| + | ''new_cdepsout.bin'' | ||
| + | |||
| + | == Running from the Command Line == | ||
Explain here | Explain here | ||
Revision as of 05:22, 25 April 2009
Contents |
Introduction
What is it?
Explain here
When should I use it?
This tool can be used when you wish to transfer the existing solution from one mesh (old) to a another mesh (new). The old and new meshes must have the same geometry but can have a different number of distribution of grid points. This tool is especially handy if you want to perform a grid convergence study on three meshes, say a course, medium and fine mesh. The solution from course mesh could be interpolated onto the medium mesh then from the medium mesh to the fine mesh in order to significantly reduce the convergence time.
Running from the GUI
Preparation Steps
In order to make things clear we will establish a naming convention. We will call the existing solution, the one we are interpolating FROM, the OLD solution. We therefore call the solution we are interpolating TO, the NEW solution.
1. First rename the following files in the NEW solution folder:
cellsin.bin -------> new_cellsin.bin nodesin.bin -------> new_nodesin.bin
2. Copy theses two files from the NEW solution folder to the OLD solution folder
= Running the Tool
To initiate the tool from the GUI go to Tools -> CFD++ Solution Tools -> Solution Re-interpolator. The following window will appear:
3. Leave the default values and select the "Run Tool" button to start the run.
Post Run Steps
4. Copy the new_cdepsout.bin file from the OLD solution folder to the NEW solution folder.
5. Remove the new_ appendage from each of the following files:
new_cellsin.bin new_nodesin.bin new_cdepsout.bin
== Running from the Command Line ==
Explain here
