Hydraulic diameter
From CFD-Wiki
Line 6: | Line 6: | ||
==Use of hydraulic diameter== | ==Use of hydraulic diameter== | ||
+ | |||
+ | ===Estimating the turbulent length-scale== | ||
+ | |||
+ | For fully-developed flow in non-circular ducts the [[Turbulent length-scale |turbulent length-scale]] can be estimated as <math>0.07 d_h</math>. This is as usefull estimation for setting the [[Turbulence boundary conditions|turbulence boundary conditions]] for inlets that have fully developed flow. | ||
==Hydraulic diameters for different duct-geometries== | ==Hydraulic diameters for different duct-geometries== |
Revision as of 14:01, 24 March 2006
The hydraulic diameter, , is commonly used when dealing with non-circular pipes, holes or ducts.
The definition of the hydraulic diamater is:
Contents |
Use of hydraulic diameter
=Estimating the turbulent length-scale
For fully-developed flow in non-circular ducts the turbulent length-scale can be estimated as . This is as usefull estimation for setting the turbulence boundary conditions for inlets that have fully developed flow.
Hydraulic diameters for different duct-geometries
Using the definition above the hydraulic diamater can easily be computed for any type of duct-geometry. Below follows a few examples.
Circular pipe
For a circular pipe or hole the hydraulic diamater is:
Where d is the real diameter of the pipe. Hence, for circular pipes the hydraulic diameter is the same as the real diameter of the pipe.
Rectangular tube
For a rectangular tube or hole with the width and the height
the hydraulic diamter is:
Coaxial circular tube
For a coaxial circular tube with an inner diameter and an outer diameter
the hydraulic diameter is: